SDR-100-031-E1
PCD Tipped Milling Insert
PCD Spec (H x L x R)0.25" x .025" x 0.031"
PCD Tip Size is 4-5 mm, thickness is .5 mm
PCD may be cost effectively employed to machine the following broad range of materials:
- Non-ferrous metals and alloys including, aluminium, copper, bronze, brass, green tungsten carbide, precious metals and MMC's.
- Non-metallic materials including, ceramics, reinforced plastics, hard rubber, chipboard, MDF's and other fibreboards, etc.
PCD may be used for both roughing and finishing work, although it is usually most beneficial when tight tolerances or high surface finishes are required combined with the need for exceptionally long tool life. It is available in three grades of increasing crystal size and toughness but with an attendant decrease of edge quality.
The finest grade is, therefore, only employed where superior surface finish is the main objective, the middle grade is the general purpose material giving long life with good component finishes; the coarse grade is used where maximum abrasive resistance is required and where finish is not critical, for example the machining of metal matrix composites.
|
 |
Price: $35.00
You save $65.00
| |
| Manufacturer |
|
| Unit |
|
| SKU |
|
| Inscribed Circle IC: |
|
| Insert Radius: |
|
| Insert Thickness: |
|
| Insert Length: |
| |
E-mail a friend about this item.
Send Page To a Friend
|
